FAST MEMS NON LATCHING
The SW series are fast, non-latching MEMS switches available both for single mode and multimode fibers. They are available in configurations from 1x2 to 1x32. These switches are mainly used in test and measurement applications.
The MEMS switching structure achieves repeatability of 0.001 dB and shows a very flat Insertion Loss over the full spectrum of the fiber.
• 1 ms response time
• 60 dB crosstalk
• Miniature size
• Optical Reconfiguration
• Protection Switching
• Network Restoration
Purchase MEMS Switches
Thank you for trusting Sercalo's products.
By clicking "Buy Now", you will be redirected to a partner online sales site.
For any further question, please contact us using the following template.
Information request MEMS Switches
The SW fiber optic switch is a very fast opto-mechanical switch based on the MEMS technology. The component is designed for fast switching between two single mode fiber ports. The switch is available in 1x1, 2x1, 4x1, 8x1 and 2x2 variants. The highly reliable switching mechanism uses an integrated micromirror and features below 1 ms switching time and only 0.5 dB insertion loss.
The miniature package withstands rugged environments and is well suited for direct mounting on printed circuit boards. The switch is qualified according to Telcordia GR 1221.
The non-latching switch modules are fast and reliable switches designed for single mode fiber instrumentation. The device is based on the latest silicon MEMS technology and uses a micro-mechanical mirror to switch light. Operated by an electrostatic actuator, the switch features fast switching below 1 ms and high crosstalk attenuation above 50 dB. The switch is powered by a 5 V supply voltage. A 5 V TTL or CMOS drive signal is used to control the switching state.
With 0 V on the drive pin (No 2) the switch is in its bar state (port 1 – port 3).
When 5 V are applied to the drive pin, the micromirror is moved out of the optical path, which puts the switch into its cross state (port 1 – port 4).
At power off, i.e. when either the supply voltage or the drive signal falls to 0 V, the switch returns into its bar state.